Model 205

webmaster

Newly re-designed in 2022, the Model 205 benchtop style PWM Controller is for general purpose solenoid design, development and drive applications, providing the highest level of functionality and accuracy.

Model 400 USB

webmaster

The Model 400 PWM Driver / Controller is intended for analog to PWM control applications and features a small, signal conditioner style package. The Model 400 is suited for solenoid drive applications where an analog output from a PLC or PC data system is used.

Model 402

webmaster

The Model 402 PWM Driver / Controller is intended for RS232 to PWM control applications and features a small, serial cable dongle style package. The Model 402 is suited for solenoid drive applications where a PLC or PC serial port may be used for PWM control.

Model 500

webmaster

The Model 500 Peak and Hold PWM Driver (also known as Pick and Hold PWM Driver) is intended for on/off solenoid control applications where reduction in power and coil heating is required. The Model 500 is suited for solenoid control applications where a digital output from a PLC or PC data system is used. The Model 500 uses timed peak and hold settings. For current controlled peak and hold, …

Model 805

webmaster

The Model 805 PWM Driver generates a high frequency, pulse width modulated, self-controlled variable duty cycle control output for proportional (current) controlled solenoid drive applications. The Model 805 also provides operational modes for peak and hold solenoid drive.

SGC 200

webmaster

The Model SGC-200 Current Sense Amplifier is intended for PWM solenoid current measurement applications where an average current measurement is desired. The Model SGC-200 is suited for general purpose measurement and monitoring applications. The SGC-200 Current Sense Amplifier provides two amplified voltage outputs proportional to the current sensed across an internal, non-inductive sense resistor. One output is an amplified voltage …

SGC 400 / SGC 401

webmaster

The Model SGC-400 / SGC-401 Isolated Low-Side Driver provides a high current, low side drive output from a low level digital signal from an embedded system, PC, data acquisition and control system digital output, or PLC digital output. The Model SGC-401 provides the same functionality and features a high side drive output. The SGC-400 and SGC-401 Isolated Drivers are intended …

DFA-100

webmaster

The Model DFA-100 Dual Channel Difference Amplifier is intended for differential to single-ended signal buffering and conversion for data acquisition systems in general purpose signal processing and measurement applications. The DFA-100 is suited for industrial control, PLC interface and automotive test and development applications.

SACT 100 / SACT 101

webmaster

The Models SACT-100 and SACT-101 are designed for control of electronic stepper motor actuators used in general purpose industrial, automotive, and commercial applications. With its built-in pushbutton / LED display interface the SACT-100 is one of the most cost effective, stand-alone, manually operated actuator controllers available.